Anschutz 1413 manual

In cases where items are reserved, a bid of the low estimate will always exceed the reserve. Reserves will be bid by the auctioneer as an opening bid so any bid taken from the floor or the phone is a live bid above the reserve amount. FFL holders may take possession of any firearm on day of sale when they present a signed copy of their Federal Firearms License.

Most non-residents may take possession of long guns on day of sale after completing the proper forms and successfully completing a NICS check; modern handguns will need to be shipped to an FFL holder in the buyer's home state. Buyer is responsible for any and all shipping charges and all items must be paid for on day of sale. Bidders should be familiar with their local and state laws as Amoskeag Auction Co. We are pleased to answer any questions you may have regarding brining your Class III items to market.

Add a reminder for this event. Print This Page. Do not use your rifle when you are tired. Tiredness may result in a loss of control. Residues of bullets, powder or oil might impair the health of your skin. Ear and eye protectionYou and other persons should always use approved hearing protection and approved shatterproof eye protection while shooting. LawsWhen using a rifle observe the corres- Product relating safety instructionsImportant note for the handling of rifles: 1.

Unload your rifle immediately if you do not intend to continue shooting. Remove the bolt or leave it open at least. In the case of a repeater remove the magazine as well. Make sure there is no cartridge left in the chamber. Make sure there is nobody in the area of case ejection. If you store the rifle remove the bolt and store the bolt uncocked in a separate place. Important note for the handling of ammunition: 1. Exclusively use clean, factory loaded and new ammunition in the caliber approved for your rifle.

Be aware that the range of a bullet starting from cal. Therefore also be sure of the safety of the impact area. Add page 5 to Favourites. The stock of this rifle has been very carefully checked by factory inspectors prior to shipment and has been determined to be free of defects. Certain kinds of abuse, such as dropping of the rifle can cause damage to the stock for which the owner is solely responsible.

We also assume no responsibility for defects resulting from inappropriate transportation mail, plane, etc. Please immediately contact your transporter in such a case. Changes or alterations to this rifle or any of its parts are prohibited. Such changes or alterations can significantly impair the safe use of our product and can lead to accidents involving severe or even fatal bodily injuries.

Any product warranty will automatically lapse in case changes or alterations are implemented. Users are requested to carefully inspect the product with regard to possible changes and alterations before use.

In case of doubt you should contact us for further information. Small bore target rifles Mod. However, do not do this until you have followed all the procedures listed below. First slightly tighten all screws.

Then tighten the front screws and subsequently the rear screws in the direction of the muzzle. For correct ad- justments we recommend our torque wrench model No. After assembly for the first time large settlements of the stock wood may occur. Consequently we suggest that you tighten the screws once more in the manner described after some time.

Check the the screws before every shooting. Carefully insert an approved cartridge with the bullet forward with the thumb into the chamber. Make sure that the bullet is not damaged. The bolt is now locked and cocked. This will cock the bolt again and eject the empty case. The safety is located on the left-hand side of the receiver. It can be operated in cocked position. UnloadingFor safety reasons the rifle must immediately be unloaded if you intend to stop shooting.

Im going to see if it has any collectors value, and if not, refinish and modify the stock. Twigg NES Member. Both are very cool!

I like. Very nice!! I have the same rifle, version. Mine is missing the hook buttplate. There might be a 2-digit number on the left side of the barrel up near the receiver that will tell you the date of manufacture. Yup thats where i got the date off mine. I have the hook buttplate, the prone buttplate, and made my own palm rest when i did 3 position. I was looking at the stock last night and if the gun isnt valuable as a collectors item as-is, im certainly going to at very least refinish it, sand and modify the stock, and put a nice tung oil finish on it like i do knife handles.

I need to make some set screws to fill the barrel mount threads that will be left after taking off the barrel mounts. Once i get this baby built up, ill update the thread with pics. That is one beautiful rifle Fooped Resident HK Guru. Tiktock said:. Click to expand Joined May 2, Messages 9, Likes Patriot NES Member.

It is impressive to both view and hold; and shooting it is something of a novelty The next two images can be rotated and zoomed, either as initially loaded or full-screen for higher definition. They were employed in the "Kraft duch Freude" scheme, or "Strength through Joy", and the organisation arranged travel, holidays and leisure events for the workers, in an attempt to improve their satisfaction and therefore productiveness.

The rifles were used in "parlour shooting" competition to foster a military ambience. It was also the name of a notorius German SS officer who had control over the selection the destination of Jews being sent to concentration camps.